In the jig size range you reference you'll be better off painting the eyes unless the heads have "flats" for the eyes so the edges of the stick-ons don't stick up off the round of the head. How are you sealing these?
06May2016 @10:10
OK guys and gals, my question is does anyone know of a
guide to use when choosing stick on eyes for jigs.
e.g.: 3mm for 1/16 and 1/32 oz jigs
4mm for 1/8oz jigs
And so forth from 1/64 thru 1/4oz.
Appreciate you guys helping out!
Dave
In the jig size range you reference you'll be better off painting the eyes unless the heads have "flats" for the eyes so the edges of the stick-ons don't stick up off the round of the head. How are you sealing these?
Thanx for replying so quickly!
I will either use Testors Clear Lacquer or Skip's recommendation
of CSI's vinyl clear coat. If you have a suggestion, let's hear it,
because I am definitely open to the great help the members of
this forum give so freely. Thanx again, Dave
I use mostly 3mm - I use DUCO cement put the eye on all of one side let dry for a few minutes flip over and do all the other sides. I don't seal the head putting eyes on just what it takes to put them on and haven't lost one yet.
I don't have an aspirin head mold so I just flatten the sides on round heads. I also use domed doll eyes to put on my jigs and haven't lost any of those yet either.
Fatman - Thanx for the suggestions. I like the idea of flattening the side of a round head!
Do you use a punch to flatten or ??
Thanx again for taking time to reply.
Dave
What's Duco?? Been planning on making a jig to put in my vice to flatten the heads slightly!
So the right size is 3mm for 1/16 oz heads?
Sent from my iPhone using Tapatalk
Micropterus salmoides thanked you for this post
Superglue gel quick set here. The tiniest drop is all that is needed. I don't seal the eyes. No problem eyes coming off.
RobJohnson LIKED above post
Dave here ia a video where I show how to do the heads for using 3D eyes. Hope it helps
https://youtu.be/OEBDuRAs6PA
Flat nosed pliers you don't need a lot of pressure to flatten them - go to far and you can crack the lead around the eyelet
Duco Cement for glueing them on
DaveB40 LIKED above post
I ordered some 3mm 3D eyes going to try it!!
Sent from my iPhone using Tapatalk