Dont make them easy to find....
Good electronics and marking your waypoints and your secret is golden!
I am planning on putting out some crappie beds soon. I am going to make them out of pvc. I have heard that pvc can be hard to find in the water. I know a lot of you fishermen have come up with a way to make pvc more visible under the water and easier to find on your graphs. Since I promise not to steal the locations of your beds could you give me an ideal of how to sink mine and easily find them next time I look for them.
Dont make them easy to find....
Good electronics and marking your waypoints and your secret is golden!
Speck LIKED above post
Here's one out of fiberglass.
1990 Stratos 285 Pro 200 HP Merc
SpyderLok Rod Holders
Proud Member of Team Watch The Finger!!!
(662) 458-8925
Fill these pvc attractors with concrete for max visibility.
If stealth mode is what your after tie them to a concrete block instead.
https://youtu.be/Qlx5nt_lfFc
Last edited by Pantastic; 05-29-2016 at 06:14 PM.
Sand the pvc and mark it with GPS it will show up if I was u I would also make some out of wood stakes I think they like wood better I like to mix mine with the pvc and wood
"G" LIKED above post
Anything hollow...I.e.- bamboo or pipe is much tougher to locate through sonar.. Like Slabin said mark it with GPS
Sent from my iPhone using Tapatalk
Strike King Prostaff
Single pole Mafia
All I can say is I've sunk pvc structures and I absolutely can't see them with down scan or side imaging. I thought trapping air inside the pipes would make them visible, but not the case for me.
Bobby McGaha
3250 Harrison St. Ste. 300
Batesville, AR 72501
870-612-5300
Securities offered through First Allied Securities, Inc., A Registered Broker/Dealer. Member FINRA/SIPC. Advisory services offered through First Allied Advisory Services, Inc. A Registered Investment Adviser.