Likes Likes:  0
Thanks Thanks:  0
HaHa HaHa:  0
Results 1 to 3 of 3

Thread: How to install tilt-trim?

  1. 02-23-2012, 08:54 AM #1
    daveywonder
    daveywonder is offline Minnow
    Join Date
    Feb 2012
    Location
    indiana
    Posts
    23
    Post Thanks / Like

    Default How to install tilt-trim?


    I cannot lift my 80 horse mercury motor to get out of the water due to weak shoulder's, and I want to install a tilt-trim package. Just how difficult is this to do? I am somewhat mechanically inclined, somewhat, and would like to save afew bucks doing this myself. Any suggestions, and maybe you can recommend a particular model to install. Tks.....
    Reply With Quote Reply With Quote
  2. 02-25-2012, 09:22 AM #2
    Shallow Runner's Avatar
    Shallow Runner
    Shallow Runner is offline Crappie Wall Hanger II
    Join Date
    Feb 2012
    Location
    Louisiana
    Posts
    562
    Post Thanks / Like

    Default

    CMC makes a pretty good cost effective one. The pt 135. Think its around $500-$600 if I remember right. I have had mine 3 years and no issues. Easy to install on boat bit check the bolt pattern on your motor and the speck sheet from CMC you may have to buy an adapter as well.


    Eatin ain't cheatin
    Eatin Ain't Cheatin
    Reply With Quote Reply With Quote
  3. 02-28-2012, 11:01 PM #3
    RCS
    RCS is offline Crappie Wall Hanger II
    Join Date
    Aug 2010
    Location
    Al
    Posts
    858
    Post Thanks / Like

    Default

    Hey Sir,
    I have one that I took off a tornado damge boat. Its like new. Harness and relays are with it. All you need is a momentary switch. Here's the link. Hydraulic Trim & Tilt. Fits up to a 135 hp or 235 pounds.
    God Bless
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

BACK TO TOP