Thread: Dual Seat Mount

I also had a Springfield mount, I believe it may have been 2 3/8. Anyhow, I had Cumberland Crappie make me his standard seat and then purchased a Springfield mount adapter. Look up the Springfield website and look for the "adapter". It adapts to a 3/4 in pin. Worked for me, might save you a lot of $. Wish you the best.

I don't think I'll go back to Cumberland Crappie due to the workmanship on what I have.

Wayne at Blackland Lures....good guy.... builds Dub-l-Seat. Built strong. Made like a tank. He can modify to fit your boat socket and paint to match your boat. Also he can customize the arms to the length you want for your boat. I have one on my old, narrow front end ranger that is 37 yrs old. I think he is a crappie.com sponsor. You can PM him using his call name on this site.... Blacklandlure. His email is [email protected]. He is in Boonevile MS and will offer you a fishing trip if you ever get down his way, lol.

HHD

E.Z.T pole perch | Jeffersonville, GA 31044

Just got the E.Z.T pole perch this spring and like it real well so far. You cant beat the price either.

I believe you and I have the same dual seat mount from Cumberland, just curious to what problems you have had with it? I have to say mine is holding up fine.

Glen

If you recall when we received these we had a tournament that weekend. When I installed it I spent about 3 hours filing and sanding the center pin so it would fit into the seat base I then spent another couple hours filing and sanding the seat mount so I could insert my power pedestal into the seat base. Whenever I remove the dual seat mount so I can go back to a single seat it takes a couple hours. I have to place my power pedestal in a vice and beat the seat base off with a dead blow mallet, then I bolt a piece of unistrut to the center pin and pry it out. The center pin has my seat base fouled up and I had to remove it last night so I could get the pedestal out for reinstallation of the double seat mount for this weekend. I probably should have sent the whole thing back to Terry, but with the tournaments we were having I didn't want to be without the dual front seat, my mistake. Anyway I'm fed up with it and am looking to replace it along with a new pedestal base. The rod holders from Terry are fine but I would never recommend him for a dual seat mount. Anyway I'll be looking at different setups and decide what I'm going to change to this winter.