With my wife’s health issues I haven’t been able to get to the lake lately so I was in a hurry when I found out for sure I could go Saturday night. Anyway I got to the ramp & the screw for my aftermarket perspective mount had came out & was lying on the front deck so I stuck it back on & took off down the lake. I realized pretty quick like that I couldn’t see my jig in the dirty water so I cranked up the gain etc. Then I went to a 1/4 oz. jig all the while thinking the dirty water was causing me these problems until I went to look for something that I thought was in the water in that area & I turned my pole mount around when all of a sudden there was my jig sticking out like a sore thumb. To make a long story short when I reattached the transducer to the pole mount I liked a couple clicks getting it up enough & was picking up off the back side of the transducer. I felt like an idiot but fixed it when I got home before hitting the hay though. If I had taken the time to look I had a pic of my install on my phone & would have been fine if I’d just have looked.