Hey guys,
I am in the process of rigging my Pontoon boat's electronics and have some questions regarding the compatibility between units that I own.
Here is my situation.
I have the following hardware:
Humminbird Helix 10 Gen 3 Mega Down Imaging +
Humminbird Helix 9 SI Gen 1
Humminbird 1198c SI
Trolling motor - Ulterra Gen 3 with integrated Mega Down Scan transducer
My plan thus far is as follows:
At the steering console install the Helix 9 for side scan imaging and AutoChart Live.
Install two HD transducers at the rear of the boat. One on each pontoon and assign them to left and right. (for side scan). This is in order to get the clearest picture possible.
You will need this Y cable https://humminbird.johnsonoutdoors.c...splitter-cable
At the bow install the Helix 10 Gen 3 mega down imaging and connect it to the Ulterra's built in mega transducer.
Now the dilemma that I am having is where should I mount the 1198SI?
Should I mount it at the bow and use it for mapping / waypoints? and potentially 360 in the future?
Is the 1198 even capable of receiving the 2D sonar from the newer Ulterra's transducer?
CHIRP will have to be shut off the CHIRP unit in order to share sonar to the non-CHIRP unit
Can all my units share waypoints?
Yes
Will the side scan imaging from the Helix 9 network / display to the 1198?
Yes
In which case I would be able to also view side scan images at the bow.
CHIRP will have to be shut off the CHIRP unit in order to share Sonar with the non-CHIRP unit
Or Option B - install the 1198 at the console and use it for mapping while I drive around looking at side scan on the Helix 9.