Thread: 7.080 update

I usually don't run that slow either but a guy on that site AL owns posted ("899 help") a problem, it was windy & I was using the i-Pilot so I slowed it down - just noticed it on the last update - I loaded 7.08 from 6.74 and right after I gave about 8 qts. of blood to the skeeters performing the update, I came back in and I had an email about 7.09!
Never actually ran 7.08 except SIM for a few minutes while I was donating blood....LOL
I have a feeling it may be a combination of 200/83 and having the DI enhance set to low....
My buddy & I both have 899's and his didn't do it - and I set the chart to 2 on his - running 7.02 - same as my 899.
So basically I went from 6.74 to 7.09 and noticed it - same exact setting as displayed though - 12/10/low....
Running chart @ 1 or 3 & it goes away.
Mystic Pizza!

Thanks Kos!

RAS

Robert,
It happens when you run the Chart Speed at 2 AND the Sharpness menu at anything other than “Off”. So if you want to use the Sharpness you just have to set the Chart Speed on anything other than the 2 setting.

That DI anomoly first showed up somewhere around 6.5xx...

HB says they're working on it...

Rickie

I had a 798HD that had the DI problem when the sharpness was anything other than off. Don't remember what software version, but I do remember it being 6.5X or later

Thank you for the explanation Greg, I will pass this on the folks on the other sites I frequent.
YOU DA MAN!!!!

I still havn't found a practical use for running chart speed slower than 3.
Even while using my onix with the 360/di mold I run a faster chart speed

Originally Posted by kosmo

I still havn't found a practical use for running chart speed slower than 3.
Even while using my onix with the 360/di mold I run a faster chart speed

What criteria do you base your chart speed on?

Originally Posted by BrownTrout

What criteria do you base your chart speed on?

I like my screen to update as quickly as possible and still be clear enough to satisfy me.(just go with it) is my criteria