I installed my Ulterra on my RT188C and now have an area where the old trolling motor was that I would like to cover. (Because I’m anal I guess) I was going to trim it to fit somewhat so it would kinda match. I texted my Ranger dealer asking what a rubber tread, like is on the right side, would cost...
Quote “The pad is 46.86 plus 9 dollars in shipping. It's a make item only so it will be about 3 weeks. “
Whew!! Any ideas?
Sent from my iPhone using Tapatalk Pro
How anal are ya? Is it worth the $55.86? Or use something like cray suggested?
Drinkin coffee, missin fish.
I had already been to Walmart and Harbor Freight and seen what they had and wasn’t even close. I’ll probably just have to pony up and order it ... I knew there were some pretty knowledgeable people on here, was hoping someone knew of something that matched a little better.
Sent from my iPhone using Tapatalk Pro
Amazon has these self adhesive stair treads, $15 for a pair. You could also tape off that white spot and spray it with aerosol bed liner. Just a couple of ideas.
Kevin
in YorktownIdragslots thanked you for this post
If you know somebody that owns or works for a commercial rubber roofs company or does maint on roofs for commercial buildings ....you might get lucky and snag a rubber tread remnant they use to put in high traffic areas like around hvac units and stuff. That's what I do. They usually have several different kinds . It's pretty expensive to buy a new section but I have managed to latch on a piece or two before.
The stuff I have got before is about 1/4" thick and black pliable rubber with like raised dimples on one side and peel and stick on the other. Works perfect .
Idragslots LIKED above post
I wouldn't waste my time or my energy looking if it for what it cost from the dealer and you know it matches perfectly.
For the cost of the boat, the TM, the rods, the tackle....you're worried about $55?
crappiemax LIKED above post
It looks fine to me just like it is.
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
Keith K LIKED above post
Looking at the age of this thread , you have probably got her done.. My thought was you would have to remove the Rubber already there on that Fiberglass hull to put the new longer strip in place... show us how it came out