Thread: Mounting a transducer on a MK power drive TM

I thought I would attach some photos of my install. Basically the same as the iboats post but my Power Drive V2 has the newer release handle. I drilled a hole in the plastic handle to pass the transducer cable. I had to make it big so the connector would fit through. I would also recommend to use electrical tape where you can. Zip ties can cut into your cable if your motor head gets turned too far creating a lot of tension. Make sure you know the running depth for your trolling motor before using electrical tape to secure the cable to the top portion of the shaft. If you tape too low on the shaft it will prevent the motor from dropping down far enough into the water.