Good plan ,I will try this!
Sent from my iPhone using Crappie.com Fishing mobile app
Good plan ,I will try this!
Sent from my iPhone using Crappie.com Fishing mobile app
I was having cranking battery issues about every third trip I’d have a dead battery. Exchange for a new battery twice. Finally just went with a onboard charger. I think the HB Helix was pulling more than my motor was charging. 8 hours fishing and maybe 15 minutes of run time. No problem since.
Sent from my iPhone using Crappie.com Fishing mobile app
KHNC LIKED above post
Transistors do not "need power even when off", that is malarkey. Some fishfinders do draw a little current when off, usually to keep volatile memory intact. The Livescope GLS10 module in my boat draws 13 mA when off, a trivial amount unless your battery is very small or weak. I don't use a switch and don't need one.
A digital multimeter is an invaluable tool for finding the "leak", but most folks don't know how to use them. The process is simple: find the wire(s) that is drawing current when everything is off, and trace it to the culprit. Usually the access to the wiring is in hard to get places, I have to lie on my back with legs hanging over the side to get under my center console. It's easier to pull the whole switch panel in my case.
A fuseholder, or fuse panel is a good place to break the circuit and insert the meter: just pull the fuse and put the Amp meter across the terminals. Remember a meter in DC current mode is like a wire, a short-circuit, and so be careful not to connect it across any voltage sources or batteries in current mode. On most meters, (I have a Fluke) you have to physically move the red probe to a separate socket for current mode - a safety feature.
"Alive without breath, as cold as death; never thirsty, ever drinking, all in mail never clinking."KHNC LIKED above post
When I put my boat in the garage, all my electronics are unplugged. A friend told me many years ago, even if they are turned off they will drain the battery. I don't know that for sure, but it only takes a second to unplug them. Never had a battery to go dead unless it was no good.
Jerry "Bo" Bryant
"Follow me and I will make you fishers of men" (Matthew 4:19)
I have a Fluke meter as well. I ordered a disconnect switch for 15.00. Probably go ahead and install it. My bass boat has one in it. None of my past boats have had one. Not a bad idea. However, i would like to track down the source, and i plan to do that as well. Need to put it in the garage so i can have time to work on it this winter.
BigDawgg, RobAnderson LIKED above post
Do what jawjatek said, that's the correct way to find the problem. Getting to tight places may be the biggest problem though. But if there is a real problem, it needs to be fixed. Don't cover it up.
jawjatek is online now
Gerald K4NHN
Cayce, SCjawjatek thanked you for this post
Installed the disconnect to all of the electronics and running lights. Left the starter cables connected. If it happens again, I will at least know it has something to do with ignition or starter solenoid. Hopefully the issue is resolved. Thx
Sent from my iPhone using Crappie.com Fishing mobile app