While repacking my wheel bearings, I discovered one of my fender mounts had broken at the weld. So today I took the boat out for a run on the Interstate to check the bearing and also get my fender welded. Everything worked fine, but I noticed the bearing cups were kind of working their way off the hub. I knocked them back in and when I got back to the garage they were again out a bit, so I trashed them and put two new ones in. They took a bit of "whacking" to seat so they should hold just fine. I took off the old ones several times when I had trouble getting the real seal to hold grease so I guess they got loose from all that.
Now I need this weather to settle down so I can make a couple of longer runs to shake everything down.
The way the wind is supposed to blow the next few days, I am not sure when that might be.