What are you using to crank down the puller? I have found an impact wrench helps.
What are you using to crank down the puller? I have found an impact wrench helps.
“If your too busy to fish, you’re too busy!” Buddy Ebsen
PROUD MEMBER OF TEAM GEEZER
(Billbob and “G” approved!)
Proud member of Tekeum’s Jigs Pro
Staff
https://heavenornot.net/
heavenornot.net
I Don't know about Kroil. I usually us PB blaster...May have to soak over night to penetrate enough...Don't know...
Proud to have served with and supported the Units I was in: 1st IDF, 9th INF, 558th USAAG (Greece), 7th Transportation Brigade, 6th MEDSOM (Korea), III Corp, 8th IDF, 3rd Armor Div.
1980 Ebbtide Dyna-Trak 160 Evinrude 65 Triumph
IMHO Kroil oil is slightly better then PB blaster. And I love PB Blaster.
Impacting my little heart to death! Dang thing, bent it, stripped it, it's garbage. This was the final try, I had done the high tension mallet hits already, I was just going for it. Something was gonna break.
S10CHEVY LIKED above post
Hmmm, what now boss?
“If your too busy to fish, you’re too busy!” Buddy Ebsen
PROUD MEMBER OF TEAM GEEZER
(Billbob and “G” approved!)
Proud member of Tekeum’s Jigs Pro
Staff
https://heavenornot.net/
heavenornot.net
My buddies saying is “I’m just gonna go for it, I’m either gonna break it or fix it”
I'm going to weigh the hammer I use and post it in a few. It puts a whack on the puller. They do not come off as easy as one would think.
So I weighed it and here is a picture, it's a NAPA 48oz Ball Peen
Now I ring the Puller Bolt pretty good sometimes 40-50 times before the Flywheels will Pop. When they do the more stubborn they are the more they want to fly. Best of Luck Bud, if you were closer I would pull it for you.