I went to look at mine and have no such setting. Then I read your post a bit closer. I have never done the updates after 2.20. I do not have that and therefore cannot help. I also checked the manual and saw no entry for that setting. Sorry, no help
I did a reset on my 93sv after an update. Everything seems to be better but i found a new setting that i did not have before. It is a tilt setting for the panoptix under the sonar setup tab. when it reset, it set it to a tilt of over 47 degrees. it made everything so crooked on the screen i could not tell where my bait was. i changed it to around 20 and its much better. just wondered if anyone else has seen this setting and if you had any comments or suggestions.. i was in 32 ft of water. i normally fish in less than 20 most often
Last edited by crappiejim; 11-25-2020 at 04:03 PM. Reason: fix
I went to look at mine and have no such setting. Then I read your post a bit closer. I have never done the updates after 2.20. I do not have that and therefore cannot help. I also checked the manual and saw no entry for that setting. Sorry, no help
I thought the "update" was for the Perspective View system ... but, I'm not sure what a tilt angle setting would be used for, even in that case (at least not THAT steep an angle change) ??
The only thing I wanted out of that update was the on-screen boat icon showing the scan direction of the transducer, so I don't have to keep one eye on the screen, one eye on the trolling motor direction arrow, and one eye on my line![]()
Notice the icon in the upper right corner of this screen picture :
I was hoping it was already there, but it is not ... until you do the update.
its a setting under ADHS.. if you turn the ADHS off it gives you a tilt option.. I got an answer on a facebook garmin group.. thanks