Search:
Type: Posts; User: JayByrd; Keyword(s):
Search: Search took 0.01 seconds.
-
09-10-2019, 02:18 PM
Thread: Crack's in Coleman canoe's
by JayByrd- Replies
- 9
- Views
- 4,906
If I were patching, I would roughen the surface a...
If I were patching, I would roughen the surface a little with sandpaper, use the cloth for fiberglass as a mat and use epoxy glue both inside and out.
-
08-09-2019, 04:02 PM
- Replies
- 236
- Views
- 48,015
Three fishermen were fishing when they came upon...
Three fishermen were fishing when they came upon a mermaid, the mermaid offered them one wish each, the first fisherman said: “double my I.Q” so the mermaid did it and to his surprise, he started...
-
07-28-2019, 09:51 PM
Thread: LAKE SECESSION
by JayByrd- Replies
- 18
- Views
- 4,789
I have stayed at the Abbeville Opera House, I...
I have stayed at the Abbeville Opera House, I would not recommend it in the winter months, the heating was terrible but everything else was fine. The kids do a great job in Greenwood at the Theater...
-
07-16-2019, 01:18 PM
Thread: Salvaging Hydraulic Assist for trim
by JayByrd- Replies
- 4
- Views
- 1,928
Yes, pin in the upper left of the diagram. I...
Yes, pin in the upper left of the diagram. I can't see the back side because of the pivot pin.
-
07-15-2019, 03:06 PM
Thread: Salvaging Hydraulic Assist for trim
by JayByrd- Replies
- 4
- Views
- 1,928
Salvaging Hydraulic Assist for trim
I bought a 2000 40 Mercury outboard 40ELPTO which had engine problems for spare parts. I want to remove the Hydraulic Assist cylinder from the transom mount assembly. The bottom pin is easy enough...
-
07-10-2019, 08:41 PM
Thread: Need advice on trolling motor
by JayByrd- Replies
- 9
- Views
- 3,024
I bought my deep cycle 27 from Wal Mart, it does...
I bought my deep cycle 27 from Wal Mart, it does fine.
-
06-28-2019, 09:03 PM
Thread: DIY Shade or Rain chair for bank fishing
by JayByrd- Replies
- 23
- Views
- 9,569
Where did you get the umbrella? I need one.
Where did you get the umbrella? I need one.
-
06-18-2019, 01:59 PM
Thread: kastking reels
by JayByrd- Replies
- 24
- Views
- 10,455
I have to come down hard on both of the KK...
I have to come down hard on both of the KK Sharkys to make the bail reset after casting. Have 3 Okuma's, a Penn, a cheap Berkley and several other cheap spinning reels, they all are smoother than the...
-
06-17-2019, 03:41 PM
Thread: kastking reels
by JayByrd- Replies
- 24
- Views
- 10,455
I have 2 KK Sharky III's, would not buy again....
I have 2 KK Sharky III's, would not buy again. Bail rough closing. Okuma's are smooth.
-
05-23-2019, 02:30 PM
- Replies
- 6
- Views
- 528
Info
I am going to save this article for future reference. I am still learning.
-
05-15-2019, 05:07 PM
Thread: I'AM GOING STRIPER FISHING
by JayByrd- Replies
- 8
- Views
- 1,969
What kind of lures work on stripers?
What kind of lures work on stripers?
-
04-21-2019, 09:45 AM
Thread: Is Greenwood really muddy today
by JayByrd- Replies
- 3
- Views
- 718
I never go on weekends. It's crazy.
I never go on weekends. It's crazy.
-
04-14-2019, 08:01 AM
Thread: 5 hrs of fishing today
by JayByrd- Replies
- 10
- Views
- 2,213
All we can legally catch here in SC is 20 per...
All we can legally catch here in SC is 20 per person, over 8 inches and 30 Bluegill any size.
-
04-07-2019, 06:41 PM
Thread: Article: Clark’s Hill /Lake Murray Wkd
by JayByrd- Replies
- 5
- Views
- 642
Saturday
It was so pretty Saturday, everybody and his brother was out. Nice fish and fun!
-
03-27-2019, 06:25 PM
Thread: Getting her ready
by JayByrd- Replies
- 31
- Views
- 4,108
Seriously, a 15 would be plenty. They are less...
Seriously, a 15 would be plenty. They are less than 100 lb. And some can be souped up to 20 with a ignition or carb change. I have a 9.5 1967 Evenrude Sportsman on my 14 ft open Starcraft. I can...
-
03-16-2019, 05:17 PM
- Replies
- 3
- Views
- 1,742
That is what I was looking for. Good thing you...
That is what I was looking for. Good thing you told me to tilt prop down, I didn't know that. Just received the seals. Got them off of E Bay much cheaper than a parts supply or dealer. Most of the...
-
33" wide, that is what I would want for stability.
33" wide, that is what I would want for stability.
-
03-11-2019, 03:01 PM
Thread: Best trailer light assembly?
by JayByrd- Replies
- 16
- Views
- 4,211
I mounted my lights near the top of the loading...
I mounted my lights near the top of the loading boat guide on the rear of the trailer. They don't get in the water when loading. I used a 3.5" (approx) square galvanized cover for a house wiring...
-
03-10-2019, 09:38 PM
Thread: Greenwood 3-9-2019
by JayByrd- Replies
- 10
- Views
- 1,432
Rode to Riverfork Boat ramp on Summerplace road...
Rode to Riverfork Boat ramp on Summerplace road and the boat trailer parking was full. Water looks pretty muddy or stained as you say. Nice fish!
-
03-10-2019, 09:33 PM
- Replies
- 3
- Views
- 1,742
Propeller shaft seal replacement 2002 40 Merc.
I need to replace the foot oil seals on the propeller shaft. The housing just close to the prop has a flange held on by 2 bolts. The motor is a 2002 OT501463. 2 cylinder, oil injection. Do I need a...
-
03-10-2019, 01:07 PM
Thread: Fish Finder Question
by JayByrd- Replies
- 11
- Views
- 2,756
Good advice, I didn't consider a bad connection.
Good advice, I didn't consider a bad connection.
-
03-10-2019, 01:04 PM
Thread: howto catch small flatheads
by JayByrd- Replies
- 9
- Views
- 4,172
Yes, in my experience the flats are the best...
Yes, in my experience the flats are the best eaters. Also they have a big piece of belly meat that is good too. I have weighed the fish and weighed the dressed meat afterwards and I get a higher...
-
03-10-2019, 12:55 PM
Thread: Fish Finder Question
by JayByrd- Replies
- 11
- Views
- 2,756
I would connect it to the trolling motor battery....
I would connect it to the trolling motor battery. Mine is. The trolling motor would not draw on the battery as hard pulling down the voltage. Also a trolling battery is made to provide electricity...
-
02-22-2019, 03:19 PM
Thread: decent crappie rod for 20 bucks?
by JayByrd- Replies
- 20
- Views
- 3,823
crappie rod
Berkley Cherrywood HD Spinning Reel and Fishing Rod Combo is $19.25. https://www.walmart.com/ip/Berkley-Cherrywood-HD-Spinning-Reel-and-Fishing-Rod-Combo/43927263
-
02-14-2019, 08:45 PM
Thread: Article: First time with Slabsauce
by JayByrd- Replies
- 5
- Views
- 505
I bought some Ted Ellenbecker Pure Gold Bait...
I bought some Ted Ellenbecker Pure Gold Bait booster for catfish. Says it is multi species including crappie, hope it will help fill our freezer. May try some Slab Sauce also. Wondering if it is...
-
02-09-2019, 08:35 PM
Thread: A different catfish stew recipe
by JayByrd- Replies
- 12
- Views
- 6,970
I like a little turmeric, couple of bay leaves...
I like a little turmeric, couple of bay leaves for flavor too.
-
02-09-2019, 08:21 PM
Thread: New Fish Finder Installed
by JayByrd- Replies
- 1
- Views
- 1,201
I made an adapter out of 1/2 plastic. The adaptor...
I made an adapter out of 1/2 plastic. The adaptor went on the old holes with countersunk stainless bolts and the new transducer bolted on it.
-
02-06-2019, 01:40 PM
Thread: Lake Greenwood today
by JayByrd- Replies
- 15
- Views
- 2,266
Glad to hear someone fishing at Greenwood, been...
Glad to hear someone fishing at Greenwood, been watching for awhile. Rabon is real close to me.
-
01-29-2019, 02:04 PM
Thread: face shield
by JayByrd- Replies
- 5
- Views
- 1,219
I would think a motorcycle helmet and face shield...
I would think a motorcycle helmet and face shield would offer protection and also keep your head warm. They are everywhere and all kinds of designs. The Balaclava fleece hoods and ski mask with...
-
01-28-2019, 08:01 PM
Thread: New fish finder
by JayByrd- Replies
- 40
- Views
- 8,701
Don't forget E Bay, doesn't hurt to look.
Don't forget E Bay, doesn't hurt to look.
Results 1 to 30 of 59
Another attachment attempt= Sent from my SM-A716U using...
Pullin' from the Pumpkin Patch