Search:
Type: Posts; User: ky-slabseeker; Keyword(s):
Search: Search took 0.01 seconds.
-
02-24-2011, 09:59 PM
Thread: I need some info on a motel
by ky-slabseeker- Replies
- 2
- Views
- 750
I need some info on a motel
Can anybody give me the name of the motel beside of lake side landing camp ground on Logan Martin ???
-
03-19-2010, 10:39 PM
Thread: Buzzer will not quit
by ky-slabseeker- Replies
- 3
- Views
- 1,531
What kind of motor do you have?
What kind of motor do you have?
-
03-07-2010, 08:56 AM
Thread: 2-Strokes are Done
by ky-slabseeker- Replies
- 60
- Views
- 11,091
I wish they would come up with a perfume that...
I wish they would come up with a perfume that smells like quicksilver 2 stroke smoke...:D
-
01-15-2010, 08:03 PM
Thread: Food Saver
by ky-slabseeker- Replies
- 14
- Views
- 2,328
I just pat my fillets with a towel on each side...
I just pat my fillets with a towel on each side after I am done cleaning my fish and they seal just fine...
-
10-09-2009, 08:12 AM
Thread: Getting bad interferance on HB
by ky-slabseeker- Replies
- 17
- Views
- 2,249
I tied into my ground wire going to my 787c2i and...
I tied into my ground wire going to my 787c2i and run a wire down to where i have the clamp around the actual trolling motor. I stripped some of the wire and loosened the clamp wrapped it around and...
-
04-21-2009, 08:16 PM
- Replies
- 11
- Views
- 909
I hope you had a good birthday brother......
I hope you had a good birthday brother......
-
04-14-2009, 10:11 PM
Thread: Morels?
by ky-slabseeker- Replies
- 18
- Views
- 3,725
I found 33 big white ones today....
I found 33 big white ones today....
-
04-07-2009, 06:34 PM
Thread: Tach Quit????
by ky-slabseeker- Replies
- 5
- Views
- 1,324
Most likely a voltage regulator, That is what...
Most likely a voltage regulator, That is what feeds the tach... common problem with a merc..
-
04-06-2009, 06:28 PM
Thread: Yamaha noise??
by ky-slabseeker- Replies
- 3
- Views
- 1,282
A leaking powerhead gasket will make a chirping...
A leaking powerhead gasket will make a chirping noise also...
-
04-03-2009, 08:25 AM
Thread: Keeping your own minnows?
by ky-slabseeker- Replies
- 8
- Views
- 2,989
Yeah I keep my own minnows at home. I go buy a...
Yeah I keep my own minnows at home. I go buy a pound at a time. Usually get around 20 to 25 dz per pound and put them in a 10 gallon aquarium with an air pump with a air stone attached. They do...
-
03-30-2009, 07:48 AM
- Replies
- 20
- Views
- 2,795
I can't tell any difference at all. If you fish...
I can't tell any difference at all. If you fish these right in the trees like they are made to do I think you will actually do better with them because you can get to fish that you nornmally would...
-
03-29-2009, 08:55 PM
- Replies
- 20
- Views
- 2,795
You will be well pleased with them. I am yet to...
You will be well pleased with them. I am yet to get anything bad from him. I have been using his stuff longer than anyone... I won't go fishing without my weedless jig heads...;)
-
03-10-2009, 07:42 PM
Thread: Weiss Lake crappie fishing
by ky-slabseeker- Replies
- 5
- Views
- 1,355
I kinda doubt it is over....more like just...
I kinda doubt it is over....more like just getting started...
-
03-07-2009, 10:29 PM
- Replies
- 33
- Views
- 4,288
You kinda remind me of a mean ol moderator from...
You kinda remind me of a mean ol moderator from another forum :rolleyes:
-
03-05-2009, 06:43 AM
Thread: Mercury trim guage problem
by ky-slabseeker- Replies
- 6
- Views
- 1,792
It will be a little round black piece with two...
It will be a little round black piece with two wires coming out of it..
-
03-03-2009, 09:06 AM
Thread: Johnson Touch Trim Problem?
by ky-slabseeker- Replies
- 5
- Views
- 2,121
Like he said it should have a manual release...
Like he said it should have a manual release valve on it somewhere. It we be somewhere around the bottom of the trim cylinder...
-
03-03-2009, 09:03 AM
Thread: Mercury trim guage problem
by ky-slabseeker- Replies
- 6
- Views
- 1,792
It is probally the trim sending unit on your...
It is probally the trim sending unit on your motor has went bad. It is what makes the trim guage work...
-
03-02-2009, 08:10 PM
Thread: Need Help On Water Pump
by ky-slabseeker- Replies
- 4
- Views
- 743
You may also want to check and make sure that the...
You may also want to check and make sure that the hole where the water comes out is not stopped up. I have seen everything in them from spiders to dirt dobbers !! Just take a stiff piece of wire and...
-
02-20-2009, 07:48 PM
Thread: Broken tip on wally Marshal rod
by ky-slabseeker- Replies
- 13
- Views
- 2,215
If you purchased from BPS just send it back. They...
If you purchased from BPS just send it back. They are really good about replacing rods...
-
02-18-2009, 08:28 PM
Thread: Ranger 373V Keel Repair
by ky-slabseeker- Replies
- 6
- Views
- 3,702
You really need to tell him about Keel...
You really need to tell him about Keel Guards....:D
-
02-18-2009, 08:19 PM
Thread: Installing New Steering Cables
by ky-slabseeker- Replies
- 2
- Views
- 2,077
It just makes it alot easier if you take the...
It just makes it alot easier if you take the motor off. Especially when you are putting the new cables back in.
-
02-13-2009, 08:13 PM
- Replies
- 15
- Views
- 2,773
Hey IBNFSHN I tried what you said and it worked...
Hey IBNFSHN I tried what you said and it worked great. It looks like it has taken 95% of the interference out. Thanks for the tip !!!
-
02-13-2009, 08:30 AM
- Replies
- 15
- Views
- 2,773
My kit showed up in a couple of days from the...
My kit showed up in a couple of days from the time I called them.
-
02-12-2009, 08:31 PM
- Replies
- 15
- Views
- 2,773
Yeah they sent me a box full of stuff to try..It...
Yeah they sent me a box full of stuff to try..It had a new power cable and some metal rings that it said to use if you were using interlink which I am not. And they also sent me a thing that you...
-
02-11-2009, 03:59 PM
- Replies
- 15
- Views
- 2,773
Trouble with trolling motor interference
I was wondering if anybody has tried the kit from humminbird that is suppose to help with the interference from the trolling motor that shows up on a fish finder ?
-
02-06-2009, 10:14 PM
Thread: 9.9 evinrude
by ky-slabseeker- Replies
- 4
- Views
- 1,802
If you have weak compression it will cause this...
If you have weak compression it will cause this problem.
-
02-06-2009, 10:06 PM
Thread: installing a depth finder
by ky-slabseeker- Replies
- 11
- Views
- 21,168
I have hooked alot of them up to the back of the...
I have hooked alot of them up to the back of the trolling motor plug without any problems.. Just be careful routing your transducer cable down the sides of your trolling motor mount so they don't get...
-
02-06-2009, 09:57 PM
Thread: Boat Repairs
by ky-slabseeker- Replies
- 13
- Views
- 2,059
It is pretty easy to put one on the steering...
It is pretty easy to put one on the steering wheel. Especially if you have a trim switch on the front of the boat. If you do you will just have to get under the dash and find a red wire and a blue...
-
02-03-2009, 10:58 AM
Thread: cooking/eating sunfish
by ky-slabseeker- Replies
- 22
- Views
- 31,801
If you cut the tails off you are throwing the...
If you cut the tails off you are throwing the best part of the fish away !!!
-
01-25-2009, 09:35 PM
- Replies
- 29
- Views
- 17,827
Buy a Food Saver brand... I use mine to put up...
Buy a Food Saver brand... I use mine to put up everything..The only thing you need to do is pat your fillets dry before you put them in the bag. If it pulls moisture through you will not get a good...
Results 1 to 30 of 100
Well looks like they are down to summer pool level (and holding) and...
Mississinewa conditions 4/8