Search:

That is the way I have always done it. However, after using this device I will only scale fish using it. No more spoons or knives for me.

I normally do not scale fish but rather fillet them with my electric knife. I have an elderly widow down the street that loves to eat pan fish. She has asked me several times to scale her some...

I have the adapters that connect to the head units. I just can't seem to locate and A/B switch that will allow me to switch between the 2.

Thanks for your input.

Unfortunately my units are pre Ethernet and I can't connect them that way. I have to find some way like an A/B switch that I can go from the small 4 pin Terrova cable to each unit separately.
...

Would you know where I can get an A/B switch that will accept the connector that is coming out of the Terrova trolling motor?

Is there any way I can connect the output from a Minn Kota Terrova trolling motor to two different head units?

Thanks for you input!

Don't fret, at my age I don't even remember getting up in the morning some days.

I just wanted to post a little update: I have just pulled all the plugs after about 10hrs. of testing and they are...

I guess I have been a little slow to post the final resolution to the problem. Thanks to sliderman for all his help. Much to my dismay the problem with the alarm going off and the engine shutting...

sliderman,

I have ran the boat everyday except Sunday and it purrs like a kitten. I still have an occasional tach episode but I am just going to watch and see what happens.

Thanks again for...

They are the BPZ8H-10 plugs.

Firstly I am running NGK plugs. I don't honestly remember if I changed the plugs at the same time the problem began. I looked at the plugs and they are all running a light brown on the electrode. I...

UPDATE!!!

I think I just posted the video of what the engine is doing on YouTube. The link is https://www.youtube.com/watch?v=TmOf6OG4e7Y

It is OK except where I dropped the phone one time.

sliderman-please check your pm.

I just came in from running the motor and it acted really weird this time in that after the engine shut down the fuel pump continued to cycle every few seconds and...

Thanks.
My internet is down.
If you have time could you send me a clue how to do it.
Could I just hook multimeter to 12vdc at the console. I think your
Diagnosis sounds very reasonable.

It is a solid tone. It remains that way until the engine shuts down. I do not have a voltage gauge. I think there is in fact some weird stuff going on with the tach. I am pretty sure it jumps...

Update on problem!!

I have not been able to diagnose the oil problem. However, apparently somewhere in the past others have had a similar issue. I talked to the local dealer and he informed me...

I wish I could go catchin!!!!!!!!!!!!

Thanks to you I think I will be able to isolate the problem. It's church tomorrow and then back to troubleshooting early Monday.
Thanks again for sharing your knowledge.

Yes, they both had what appears to be a neoprene O ring on the cap. As far as the 4psi check valve it is located in the t connector where the oil line connects to the engine tank. It is not in the...

sliderman,

Thanks so very much for taking your time to help me trouble shoot my problem. The great thing with having someone of your caliber to help is that you obviously know what you are talking...

I actually replaced the tank with a new one and had the same results as far as the alarm going off. I did not know at that time that the oil was bleeding out of the tank. Does it seem reasonable that...

I will do that first thing in the morning.
Thanks

I have what is apparently an unheard of problem with my oil system on my Merc. 150. When I tilt the engine up the oil in the tank on the engine drains somewhere. I have not proven it but I think it...

My 2002 Merc 150 EFI is sounding a constant alarm and then engine shuts down. The DDT tells me it is the Oil Tank. However I have replaced the oil tank although the old one tested good. The new one...

MY OLD GARMIN 240 JUST GAVE UP THE GHOST. DOES ANYONE HAVE ONE FOR SALE OR KNOW OF ANYONE THAT DOES?

THANKS FOR YOUR HELP.

I recently had the ocassion to communicate with Jack Wells at BnM Poles. I am, by all standards, considered to be a senior citizen. I have been at this fishing game for a very long time. I have...

I need to mount a transducer in the bilge area of my boat. The x-ducer comes with epoxy to mounit. Because of the area that I have to mountn it in I am concerned that if the x-ducer goes bad I will...

WB,

Great advice regardless of what time of the year it is. Problems occur even with good Maintenance schedules and more frequently without a good PM.

Murphy's law is more applicable when you...

Regardless of what kind of anchor you finally decide on be sure and get yourself about a 5 or 6' length of heavy chain to attach your anchor to the rode/rope.
Thumbs Up

X 1000!!!!!!!!!!!