Powder Coating Paint Supplier
Lots & lots of colors. So far i have not had to do anything to the red sickle hook eyes. No idea why but the translucent teal does not stick to it but is hard as nails on the lead part
The painted heads look great KAG, nice work. You have the plastic baits up side down, do you use them like that.
PROUD MEMBER OF TEAM GEEZER ---------
Ascend 133X 13' - MotorGuide Xi3 & Mercury 4
I like the translucent but I'd also like a solid in it also. What cure times were you using??
I have been using ever since it came out and I found that the heat gun for heating the jigs is the best way.I also use the fluid bed for a better finish and I bake for a harder finish.If the eyes have bake on paint just heat up a paper clip tip red hot and it will go right though it and clear the eye.If you want to powder paint spinner bait and not the hook just heat the body and not the hook.When dipping dip hook first then with a small brush brush off the hook then hang and bake...............woody
The first pictures is the flame that I use attached to 20 lb cylinder.......been using for years on same tank.
These are the finished products headed west tomorrow.
http://litewirehooks.com/
[email protected]
Every day you do not fish will be one day less you have to fish
Here is a cheap idea I wanted to share about powder painting. Take your wife's cookie cooling sheet and bend it in half. I can hold over a hundred jigs and they all fit in my toaster oven.
Jighead you didn't get whacked for appropriating the wifes stuff!!!!!!
What type of filter material are y'all using in the beds?