Get you some clear powder and mix with your colors and you should get good results. I use a 50/50 mix.
Need some help from you guys. I don't pour many jigs, just for myself. Started reading about fluid beds and figured I'd build one just to see how it worked. Well I built 3 and they work fine with Chartruse, Green chr and Pink. My problem is with Black which I had read could be a problem and some Red. My Red has always seemed a little thick and not as light as the other colors. When I dip either one I get it to thick and in the fluid bed they just lay there and it blows out the side around cup edge red worse than black. I can't get either to lift at all. Thanks for any help you can give me.
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979
Get you some clear powder and mix with your colors and you should get good results. I use a 50/50 mix.
Thanks Len iwill try that. Is that normal for Red to be like that. It even try's to lump up.
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979
Cray
My problem color is white. Some colors are heavier than others, try different filter material. I was lucky enough to have several members send me some different size's of mesh, and for the heavy powders I use a looser style mesh which lets more air to flow through. Try different materials for filters.
Thanks for the reply StumpHunter. The paint I'm using is Protec and the Red seems like there is something wrong with it to me. It wants to clump and will look like it has moisture in it. Don't know if it all does that or I just got a bad batch. It has been like that since I first bought it.
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979
Cray how did you build it?
Here's a link to the fluid bed I built and posted on http://www.crappie.com/crappie/jig-t...bed-build.html
I followed Fatman"s post except i had a peice of 4in trim board laying in the shop and i cut it long enough to mount 3 side by side about 4in apart. and instead of the brass fittings he used i found a pack of valves and T's in PetSmart that are white plastic.The valves have a end that is long enough to go into bottom of cup. Used the T's and short peices of hose to jumper it all together and hooked to dual outlet pump. I also could not find the addhesive he used but i found a Loctite product in Lowes that works similar to liquid nail. it is white and my board was white so got it. It works pretty good since i havent torn it off yet. This all sounds complicated and looks complicated but is really simple once you start. My hardest thing was actually finding the 2 fittings Fatman used on the shelfs at lowes.
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979