i guess thats why the bite is so good at ef u aint been out sore lippin em..good luck hope its the starter and not some wiring gremlin that takes forever to find,,ther is a place on spring grove but dont remember the name sorry
makes perfect sense to him, Herb. must be in the sauce already!!!!!!!!
Just an idea for troubleshooting, try putting the engine in neutral and either pulling the pull rope to see if a piston or ring is bad causing friction. Or maybe turning the prop by hand in gear with kill switch off ignition.
No pull start / rope on the motor......
Cleaned all connections ,Did some checking with a volt meter , jumped the sylanoid ...... Pretty confident it's the starter ..... Took starter to J&N auto electric, they tested and said starters bad...... They can rebuild or get a new aftermarket one..... Not a big price difference between either, new aftermarket has better warranty ......
Harry's partner, thanks for the invite , but won't be able to make it..... Try and keep T-bone out of jail.....
T-bone , been sore lippin em in dad's boat , he's got a hds10 with structure scan, I'm finding all the rest of your stake beds I didn't have wpts on....
I no pull start either (dude its a 150)..sorry for confusion....pull starter off the motor and take it apart, clean armature then check brushes....Johnson brushes will break off...can't see it unless you disassemble it completely. That's what causes short/heat. I will rebuild it for 20 less than J&N and I'll get brushes from them...get it? PS...pull starter, I meant to pull starter off motor, not pull start, my bad, sorry for being vague. Sometimes I type what I'm thinking without considering the reader.
Sorry u guys can't make it to swap meet. Send Jr. Wick should try to come too! It will be a blow out with perhaps 40-50 fisherman....that's not counting the card players and MMA participants/events.. I will have to have three card tables and have Mike deliver hoggies all night long.Try, if you cant its OK, ur always welcome James.
Harry, Get the Net !!!
Harryspartner ....... LOL oh I got it now...... I will prob take a crack at rebuilding it then...... I did clean the shaft the little gear that engauges the fly wheel rides on ...... That gear was sticking up on the fly wheel , not going down..... Still no dice ( it does engauge and disengage like it should now ). It's off now so I think I'll start taking it apart and see if I can do something with it ....... I would send JR , but he's not so JR anymore..... He'd prob hurt the midget Mexican in the MMA events ha ha
James,
I had same problem with my starter a few years back, took it up to Dayton Started,
they tested disassembled it & found bad connection on either brushes or ground wire inside started.
Cleaned connection & worked great, at NO CHARGE!!
I'am sure if you call them they will quote rebuild cost to you.
I would check all connections inside if you disassemble it, maybe same as mine & easy fix.
If not call them.
Dayton Starter
4025 Salem Avenue Dayton, Ohio 45416.
PH# 937-277-8371
Good luck, see you on water at EF!!