Let her fill half way before bilging. You’ll have way less motion sickness next day
I have a Skeeter 20I. If you are familiar with this setup, it is a nightmare and very difficult to get to bilge pumps, livewell pumps, hoses, etc. I have not fished since last year. I noticed a small leak, as when we are fishing, the bilge pump comes on after a few hours and drains the water. This happens once or twice on a trip. I just noticed it last year, and I am guessing it’s one of the hoses and/or fitting. What is the best way to find out where the leak is? Thanks.
Let her fill half way before bilging. You’ll have way less motion sickness next day
Billbob LIKED above post
Process of elimination. Try a trip with zero water in livewell. If no leak, If separate live wells, fill/run one at a time one one trip And one the next. At least this way you have an idea if it’s one thing or the other. Could fill with a hose and leave it on recirc on the trailer and see if the water drains out. Hard to run this stolid down by looking at everything at once.
Wannabe...
Sent from my iPhone using Tapatalk
Wannabe...v2.0
A lot like the old Wannabe... except with fewer bad words. And Karate chop action. But, yes, still purtier than you.
I had a skeeter that leaked and it was a thru hull fitting on the back of the boat.I put the boat in and raised the cover in the bilge area after it being in the water 25min.You could see a drip off the thru hull fitting,it had a crack in it.
Sent from my SM-S907VL using Tapatalk
plug your livewell drains before going out next time to test
mine had a breach in the drain hose just under well where hose bends/makes 90 to run aft
Last edited by ecoast; 03-07-2021 at 11:18 AM. Reason: cain't speeel