No I don't think it will?it will only work to wake up the Ls box and the like
Re-downloaded upgrade and ran it on both units. They both upgraded to v2.5. SCORE. Can view map card on both units.
Next small problem is the yellow wake up wire doesn't wake up the other unit. Hmmmm?
No I don't think it will?it will only work to wake up the Ls box and the like
A gun, like any other source of power, is a force for either good or evil, being neither in itself, but dependent upon those who possess it
From an old movie I saw
They told me at bp to putt I like that because it was better. So I did just as told and glued it to lowest point in hull without any air bubbles and let it set for 24 hrs.
Well,, you were given 'BAD' info. The 'Skimmer' ducer can be glued in hull, but NOT the SS. See if you can get it 'unglued'. Then mount it in transom area where it will be in water and without anything out to the sides. I doubt if you break it BP will do anything about it. Sorry <*)}}}><
You'll see the difference,,,on the end of your line! PROUD MEMBER OF TEAM GEEZER
Dammit I will try. They even picked out the glue for me and gave me advise about how to do it.
What Is the glue that they gave you? Brand name and type of Glue? Silicone..... Epoxy...or other?
I will try to determine how to remove it , IF possible without damage to SS module or boat.
What is your hull made of?
Last edited by dfar; 03-16-2014 at 11:44 AM. Reason: add words
It has taken half of today got it and cleaned off stuff very minimal scratches. I now have it mounted on rear of boat ready to try it out . THANKS for the help I hope it works now. I probably better reset cuz I have tried to set it so im sure its way off.
Just 'Restore Faults' and you should be fine. <*)}}}><
You'll see the difference,,,on the end of your line! PROUD MEMBER OF TEAM GEEZERHookin'&Cookin' LIKED above post