HaHa HaHa:  0
Page 1 of 3 123 LastLast
Results 1 to 10 of 24

Thread: Mono vs Braid

  1. #1
    Join Date
    Feb 2017
    Location
    MS
    Posts
    83
    Post Thanks / Like

    Default Mono vs Braid


    Anybody out there run braid for pulling cranks? How much depth do you gain because of the line diameter difference vs the mono. Thinking about making the switch over to 20lb braid. I've heard that 20lb braid is the equivalent of running 6-8lb mono which would make baits run much deeper then my mono set up.


    Sent from my iPhone using Tapatalk

  2. #2
    Join Date
    Jun 2010
    Location
    Cleveland, Mississippi
    Posts
    4,658
    Post Thanks / Like

    Default

    Bout a foot or two difference. The more line out the bigger the depth difference. I stagger my rods in 10 ft increments with my deepest rod being directly on the depth the fish are holding at. Always rather be above them, generally the fish tell me the depth they want it at and adjust from there


    Sent from my iPhone using Tapatalk Pro
    Likes Snubby, satdoc1 LIKED above post

  3. #3
    Join Date
    Feb 2017
    Location
    MS
    Posts
    83
    Post Thanks / Like

    Default

    You running mono or braid?


    Sent from my iPhone using Tapatalk

  4. #4
    Join Date
    Jun 2010
    Location
    Cleveland, Mississippi
    Posts
    4,658
    Post Thanks / Like

    Default

    Braid


    Sent from my iPhone using Tapatalk Pro

  5. #5
    Join Date
    Feb 2016
    Location
    Olive Branch, MS
    Posts
    2,961
    Post Thanks / Like

    Default

    I think most run braid to more easily bend hooks when hung up on a stob, brush pile or a 30 pound catfishes face, also it's more durable than mono. I use mono myself, the depth your going to gain is not that much in my opinion, like MO said maybe a foot or two at best. Don't know how deep your planning on getting you cranks down too, but for me to have more than 75-80 foot of line out is very unusual. I don't like reeling them in that far, LOL. If I had to go deeper than 15' or so I might just use weights instead of pulling 150' of line behind the boat.
    Likes satdoc1 LIKED above post

  6. #6
    Join Date
    Feb 2017
    Location
    MS
    Posts
    83
    Post Thanks / Like

    Default

    Just looking for the strength loosing $8 crank on a brush pile hurts the pocket book! Some articles and forums I read guys said braid throws off your depth. Last year was my first year pulling cranks so I went with the mono. Been looking at a couple spools of 20lb spider wire braid in my garage thinking about swapping all the reels over. Just wasn't sure still a noob to the pulling cranks deal.


    Sent from my iPhone using Tapatalk

  7. #7
    Join Date
    Jun 2014
    Location
    Ky
    Posts
    4,643
    Post Thanks / Like

    Default

    I use braid to have enough muscle to pull out snagged cranks and to man handle cats and drums, etc. braid will run a little deeper. Just watch your rods as you go across a known depth flat. When they start jumping you can adjust your charts to your set up. While I started with mono I switched to braid and started saving more lures. Have fun with whichever you use. Braid will slice your hand like a knife though so be careful.
    Likes arkcrappie, Snubby LIKED above post

  8. #8
    Join Date
    Mar 2011
    Location
    MS
    Posts
    29,116
    Post Thanks / Like

    Default

    I use 40lb braid, have for several years and the loss of crankbaits went down dramatically!
    1990 Stratos 285 Pro 200 HP Merc
    SpyderLok Rod Holders
    Proud Member of Team Watch The Finger!!!
    (662) 458-8925
    Likes crp4570 LIKED above post

  9. #9
    Join Date
    Jun 2006
    Location
    Ridgeland, Ms.
    Posts
    966
    Post Thanks / Like

    Default

    I use 15/4 power pro. I like it don't run as much line out.
    Bobby Garland Pro Staff Bass Pro Shop Pro Staff
    Hi-Tek Pro Staff
    Denali Rods Pro Staff Road Runner Pro Staff
    K2 Coolers Pro Staff
    Thanks satdoc1 thanked you for this post

  10. #10
    Join Date
    Feb 2011
    Location
    ky
    Posts
    258
    Post Thanks / Like

    Default

    I stated out running Depth Hunter Power Pro braid 40/10 so I did not have to go out and by any line counter reels. About the only issue that I have had is when you get a crank bait wrapped up in your other line it can take some time getting the mess out.


    Sent from my iPhone using Tapatalk

Page 1 of 3 123 LastLast

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

BACK TO TOP