watching
Has anyone every replaced one of the cone shaped clamp screw washers. Lost one, got a couple of replacements for 99 cents, but the hole in the washer is smaller than the post it needs to slide onto. Do I drill the hole bigger, feed onto post, then somehow make the end of the post larger so the washer doesn't fall off?
watching
Cup goes on and the retainer holds it from falling off when loose. Sounds like you need the correct cup/washer and retaining clip. If you are determined to use the washer you have, drill it a little and use a small spring clip.
grizwilson thanked you for this post
You'll need P/N 2011710 and P/N 2333000.
Minn Kota Transom Mount Clamp Washer (2-Pack) - Trollingmotorparts.com
Chris
BuckeyeCrappie LIKED above post