Can you post some pictures?
What's the best way to mount a Minn Kota Terrova. Boat has a pretty installed mounting bracket but because the motor has to be slid so far forward only the back pair of holes sit on the bracket where I can reach under it.
Thanks
Sent from my SM-G975U using Crappie.com Fishing mobile app
Can you post some pictures?
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
The Terova does sit way forward
The love for fishing is one of the best gifts you can pass along
I'm at work at closest picture I got that would help. Wife's gonna send me more
Sent from my SM-G975U using Crappie.com Fishing mobile app
To reach the front ones I have taken a piece of wood and taped a 7/16 wrench to it. Used nuts with the built in washers as they would sit in / on the box end wrench. Reach up in there and prove around until you get the nut started. On an aluminium docked boat I would use 1/4" stainless steel riv- nuts in the front. They can be installed through a blind hole
The love for fishing is one of the best gifts you can pass along
Awesome looking boat by the way
The love for fishing is one of the best gifts you can pass along
Thanks DSJ.
I had thought about using these. 1/4 x 20 thread
Sent from my SM-G975U using Crappie.com Fishing mobile app
If needed you can also make your own holes in the trolling motor base. I had to do the same with my ultrex. Drill a pilot hole and finish with 1/4.
Sent from my SM-S215DL using Tapatalk
LadyBear LIKED above post
Come to think of it Minkota has some type of blind hole mounting fastener. I will see if I can find it
The love for fishing is one of the best gifts you can pass along