Here is a link to a discussion about the same problem you are having
Ulterra not fully deploying [Archive] - Walleye Message Central
My ulterra acted up and wouldn’t stow. I finally got it to stow but now when it deploys it will only stand the motor up. It will run the motor up and down with the trim function. I did the trim reset but didn’t change anything. Any ideas? Thanks in advance!
Sent from my iPhone using Crappie.com
Here is a link to a discussion about the same problem you are having
Ulterra not fully deploying [Archive] - Walleye Message Central
The love for fishing is one of the best gifts you can pass alonggrizwilson thanked you for this post
Thanks Jack.
“If your too busy to fish, you’re too busy!” Buddy Ebsen
PROUD MEMBER OF TEAM GEEZER
(Billbob and “G” approved!)
Proud member of Tekeum’s Jigs Pro
Staff
https://heavenornot.net/
heavenornot.net
To reset your Ulterra, per Minnkota customer service I was told
Power off for 3 seconds
Power on and then press power button 3 times within 3 seconds
This should reset the control board and bring the motor back to the home position
I have had to do that several times, hope it works for you
grizwilson thanked you for this post
Figured it out. I had a issue with my plug which caused low voltage. When I got that straightened out I had trimmed the motor up before stowing it. When I deployed it it was going to the last height position. When I trimed the motor back down it deployed like it should. Thanks for the reply’s!
Sent from my iPhone using Crappie.com
BuckeyeCrappie, Tradbow LIKED above post
Glad you got it sorted out.
The love for fishing is one of the best gifts you can pass along