post a picture, can't give accurate advice................
I have 20 years of sun fading on my motor. Any magic potions to bring it back? Don't expect original, just better.
Sent from my SM-G960U using Crappie.com Fishing mobile app
post a picture, can't give accurate advice................
Yes, some pictures would help a lot.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
yes take a few pics. Here's why, I have a 1980 'rude 100 HP when I got it it was VERY faded. I took pics to have a record of what the decals looked like, sanded it down a little and repainted it as near as I could to original. Then I ordered new decals from a place that sells them and replaced them on my motor. Right now I don't have the name of the place, but when it's daylight and I get out I'll get it off the decal they sent with their name on it.
smiles are contagious, spread them around
Proud Member of the ZIPPER Club
& Team Geezer
you can get it wrapped and new decals .
Here you go www,outboarddecals.com if they don't have the graphics to make yours send them the photos and they can make them.
smiles are contagious, spread them around
Proud Member of the ZIPPER Club
& Team Geezer
If it's not faded too bad, you might have some luck wetsanding and buffing. Worth a try at least.
If it is totally degraded down to the aluminum, or cracked on the cowling, you're better of repainting.
Here's the best I have. It's covered in winter crud.
Sent from my SM-G960U using Crappie.com Fishing mobile app
I thought maybe someone with a fiberglass car or boat used an off the shelf restorer. What do I know... I just fish from it
Sent from my SM-G960U using Crappie.com Fishing mobile app
moskeeter56 LIKED above post
Try scrubbing bubbles, scrub with soft bristle brush and rinse with water , wipe with 50/50 water and vinegar