I have a Crestliner 1754 with a built in 22 gal fuel tank.
The tank has a small crack in the corner near the location where throttle cables go thru hole leading back to the engine.
This was done by previous owner when he tried to fish wires.(at least that’s what I was told)
I can access this area after removing the control box and pushing cables out of the way. That leaves me with a very limited area to work on crack but manageable.
I tried to heat(melt) crack with soldering iron and then using zip ties to fill area of crack. Then a small amount of JB weld marine grade on top of that. (It lasted a while).
Wondering if I used the plastic from old gas tank and melted it over crack it would be better????
Sorry for the terribly long post.
Any suggestions would be appreciated.


Sent from my iPhone using Crappie.com Fishing mobile app