Check all fuel lines, Run some Sea Foam thru it, then new plugs. Its a start.
Smooth idle in park. Rough at idle speed eventually cuts off. Runs great anything over idle speed. Below is a video of the skipping. What do you guys think?
Shared album - Greg - Google Photos
Last edited by Big tiny; 07-17-2019 at 12:04 AM.
Check all fuel lines, Run some Sea Foam thru it, then new plugs. Its a start.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
2006 Mercury 150HP Outboard Parts | Boats.net
Open this page, find your model number or post it here. When you open your model number look on lower right side of page for vapor separator. If you haven’t you need to change filter. Need to open vapor separator and check for water and clean. Also check the float Assyrian. They are bad about sticking and if they do that electric pump will run out of fuel. I suspect that is or could be what’s happening to you. When wide open enough vibration to keep it from sticking. They also came out with a upgrade float kit for a lot of those motors.
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979