Tying to get photo to send
Sent from my SM-G960U using Crappie.com Fishing mobile app
Here is today's outcome.
This is after 5 minutes. This is also the 3rd impeller this year and not one of them last more than 5 minutes. This time the housing and all pump parts were replaced. Still lasted 5 minutes and this time the key came out in 2 pieces.
Tying to get photo to send
Sent from my SM-G960U using Crappie.com Fishing mobile app
Are you putting the impeller in with the vanes bent in the right direction ?
Sent from my SAMSUNG-SM-G891A using Crappie.com Fishing mobile app
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
silverside thanked you for this post
I put it on turning clockwise and the vanes are trailing
Sent from my SM-G960U using Crappie.com Fishing mobile app
You need to figure out proper rotation for the pump. Being installed backward is only reason I can see that would cause those problems. If it is trying to turn backward the veins are going to try to roll over and will tear off or bind up and melt from heat. And that's only thing I can and if your not lubing the housing you need to coat housing with some gear lube or oil.
Thanks cray. I did spray all parts with wd40 when assembling.
I will check into the rotation again. Making me more crazy than i already was.
Sent from my SM-G960U using Crappie.com Fishing mobile app
Did you install using lube on the Impeller,,, And is it the correct one for the HP of the motor
Yes. Every time.
Sent from my SM-G960U using Crappie.com Fishing mobile app
I use vaseline when I replace impellers.....and Cray is right if you have the rotation wrong it will tear the vanes off after awhile and usually it wont pump water good either.
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
I always use dishwashing soap to lubricate the impeller. It won't leave any oil residue in the cooling passages.