Thread: Shifter removal questin

Push in the neutral button in the center of handle, pull shift into full reverse, carefully pry the center button out with a couple is small flat blade screw drivers , under that button is a retaining bolt, 5/8 socket will take it out, then remove the covers, lower first then upper, you'll see three screws that hold the outer plate to the control box, aluminum peice , then remove outer plate, when going back together reverse sequence, care reinstalling handle , make sure it goes back in the same position you removed it from and check for neutral lock before putting retainer bolt back in, a little trick is to put electrical tape over the socket opening then put bolt in so tape stops it from sliding into the socket , reinstall button after you check for proper operation

Thank you very much sir. Do you use jigs?