Reply With Quotetrim solenoid has gone bad...you have two one for up and one for down.....so for a quick test....just swap solenoids and then you can verify it.
Likes: 0
Thanks: 0
HaHa: 0
Keeper
problem with trim on alumicraft
I tried to tilt my motor up to take out the transom brace. All it wanted to do was click I don't believe it to be the battery because the motor turns over fine. Could it be a wire curoded over or do they have solenoids that can go bad.
Super Duper Moderator - 2012 Crappie.Com Man of the year & 2018 Crappie.com Decade of Exceptional Service Awards
* Crappie.com Supporter * Member Sponsor
trim solenoid has gone bad...you have two one for up and one for down.....so for a quick test....just swap solenoids and then you can verify it.
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
Keeper
Crappie.com 2019 Man of Year, Supermod & Moderator of the Mechanics Forum
* Crappie.com Supporter
Take something like a large screwdriver and use the handle to gently tap on side of motor as you hit the switch. Sometimes the brushes will stick and motor won't run. Do not beat on it very hard because you can on some motors knock the magnets loose.
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979
Posting Permissions
