Likes:
0
Thanks:
0
HaHa:
0
-
Booger1 on the TN board has one his brother made. I have fished in one side and it works fine. You need 2 pieces of 2x2 tube 2 inches long. You also need 1 piece 37 inches long. Weld each one of the 2 inch pieces on each end of the 37 inch piece. You will need to weld a 3/4 inch nut under each of the 2 inch pieces at the bottom of the long piece. Get 2 11 inch ( threaded about $13 each) seat pedestals and screw them down into the 3/4 inch nuts. Of course you have to drill holes in for the seat peds to go thru. drill a 3/4 inch hole in the center and get you a 3/4 bolt 8 1/2 inches long. Screw it into the hole your seat normally goes in. sounds a lot more complicated than it is.
Last edited by oldwun; 09-09-2008 at 09:29 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
BACK TO TOP