Are you referring to fish symbols? If so I would turn off fish ID.
You shouldn't be picking up prop wash since it is behind the boat. If your boat is riveted aluminum you could be picking up aeration from hull.
I have a low end Lowrance device. The transducer is transom mounted. I have a 9.9 outboard. My issue is when running I get false indications of fish. I know it is prop wash. Does anyone have any ideas of a way to help curtail this problem? It’s not a make or break thing for me, but If possible I would like to stop at least some of it. I am thinking of acquiring a new Garmim someday but would like to not have the same situation with it.
Catch all you can when you can!
An old man in his old boat having fun!
FISHING REPORT: ‹Caught two docks, 3 trees and a stump- threw them back!
Are you referring to fish symbols? If so I would turn off fish ID.
You shouldn't be picking up prop wash since it is behind the boat. If your boat is riveted aluminum you could be picking up aeration from hull.
Mstr Dan LIKED above post
Catch all you can when you can!
An old man in his old boat having fun!
FISHING REPORT: ‹Caught two docks, 3 trees and a stump- threw them back!
What model Lowrance?
“If your too busy to fish, you’re too busy!” Buddy Ebsen
PROUD MEMBER OF TEAM GEEZER
(Billbob and “G” approved!)
Proud member of Tekeum’s Jigs Pro
Staff
https://heavenornot.net/
heavenornot.netMstr Dan thanked you for this post
Hook2 4xgps Lowrance is the model.
Catch all you can when you can!
An old man in his old boat having fun!
FISHING REPORT: ‹Caught two docks, 3 trees and a stump- threw them back!
I found this. I believe you will find it in settings. The video is helpful for using settings etc, the manual discusses installation and use.
Lowrance HOOK2 4x GPS Fish Finder Settings - YouTube
https://www.gpscentral.ca/manuals/Lo...ser_Manual.pdf
“If your too busy to fish, you’re too busy!” Buddy Ebsen
PROUD MEMBER OF TEAM GEEZER
(Billbob and “G” approved!)
Proud member of Tekeum’s Jigs Pro
Staff
https://heavenornot.net/
heavenornot.netMstr Dan thanked you for this post
Bullet Skinner ‘ducer installation guide.
https://d1xmkx19apgl7d.cloudfront.ne...-14013-001.pdf
“If your too busy to fish, you’re too busy!” Buddy Ebsen
PROUD MEMBER OF TEAM GEEZER
(Billbob and “G” approved!)
Proud member of Tekeum’s Jigs Pro
Staff
https://heavenornot.net/
heavenornot.netMstr Dan thanked you for this post
Make sure your transducer is not directly behind a strake on the hull. This will as mentioned above, cause an air pocket or wash that interferes at speed.
Sent from my HD1925 using Crappie.com Fishing mobile app
Mstr Dan LIKED above post
I gave a buddy two older Lowrances once to install on a small boat he wanted to crappie fish out of. He said man i don't believe that thing's are right it shows thousands of fish. I stopped by one day just shooting the bull & he mentioned it again. I looked & he had the transducer 90 degrees out. Instead of it facing to where it would read below the boat he had it turned in reading the transom instead. You talking about making fun of him i did. .
Mstr Dan LIKED above post