Found this on a quick search. Tracker Boats Wiring Diagram | TackleReviewer I always hate tackling electrical without a schematic. I would for sure double check the color codes before relied on it completely though.
Thanks for posting. Perusing that list, it makes me wonder about the mystery No. 1 switch. Does anyone think that could be depth finder? The depth finder has never worked for me since I bought this boat, which was almost 20 years old when I bought it. Just wondering if they would have assigned depth finder to No. 1 position. Maybe I can see what color wires come out of that switch and check the list.
~~~
Bill
Number 1 switch could be an accessory switch
2018 G3 Sportsman 17
2018 Yamaha F90 four stroke
Ultra 106sv bow/console
Livescope Terrova 24v Ionic lithium batteries
Thanks for reply. What does that mean? A bilge pump or livewell fill pump is not an accessory? I guess I don't understand the terminology. Now, I did find an image of a boat like mine after doing an extensive search and I could read "ACC" on one of the switches. But seems to me, every switch is for an accessory, so, I don't get it.
EDIT: Maybe an ACC light would be for something in the future you want to assign it to?
Last edited by livemusic; 03-29-2021 at 08:51 AM.
~~~
Bill
I have run into some adventures over the years and one thing is sure. Anything could of been done to the wiring. I would start by exposing the wire so you can check color code. Mice can cause one much grief as some wire insulation used soybean in it and draws them like a magnet. Take a note book along and make yourself a map that makes sense to you.
Accessory switch would usually power a fish finder, cigarette lighter port, radio, etc. Now with the newer technology fish finders, we have learned that interference comes from connecting them to the dash switches like that so almost all rigging for fish finders goes straight to the battery.
had same problem and it nearly drove me nuts. the switch is wired 12volts to center of switch (pin 2) and jumper to the other side of switch(pin 5), anchor lite is wired to pin 1 and jumper to pin 6, nav.. lite is connected to pin 3. found that my lights are wired backwards and once both are working that's how they will remain. the main trouble was a dirty push on connector on pin 3. if this sounds confusing drop me a PM with your phone number and maybe i can explain it better.---shu
<*(((((><
Yes I’m saying stern light should come on in both positions of switch, but bow light should come on in only one position. So if bow is not working and stern is working in both positions then problem is between switch and light. You might try swapping the two wires on out side edge of switch and see if bow comes on. If it doesn’t then that tells me you have a problem in wire to light or in the light connector that light plugs into.