I fixed your "fat finger oops" Grandpaw .... no blood, no foul.
... cp
wondering what you folks are using for multiple rod holders.
i have one Mr Crappie, rod holder (holds 4 rods) thats never been used, thought about buying a couple more of them and putting 2 of them in the front and 1 in the rear towards the middle. This is a new Bennington 22ft sffx, fishing toon, with the fishing seats in the 4 corners, trolling motor on the front that i just bought in Sept.
any other suggestions ?
wow, i fat fingered BOAT, on my 1st thread, hope the spelling police don't run me off haaaa
Last edited by CrappiePappy; 11-05-2013 at 04:48 PM.
I fixed your "fat finger oops" Grandpaw .... no blood, no foul.
... cp
If you got run off for misspellings or bad grammar there would only be 3 people left people on the forum.
Mark 1:17 ...I will make you fishers of men
I often guide out of a 22 ft pontoon and had the same problem. T-bars do not work well on a pontoon rail because they shake too much. It seems that the boat's rail magnifies the shake of the boat and sends it into the T-Bar. I was not pleased at all with this. I then came up with a system that works really well for me and allows great versatility in your setup. I have pictures and if you send me an e-mail I will e-mail the pictures to you and explain the system. I actually have two different ways of attaching rod holders with a lot of versatility. These items are not on my website at Extreme Fishing Concepts My email is [email protected]
Driftmaster makes several types of rail clamp.
Here is what i talked about in my other post. It changes the square tubing into round tubing that makes everything completely adjustable. On the back of the boat it also got the rod holders up higher so that they were easy to reach without moving from your seat. Everything is easily installed and easily removed. I have these all around the boat. I should have put another rod holder on for this picture but I hope you get the idea. This is the front of the boat shown but the back of the boat is where it works the best.
Scroll down to "Pontoon Holders"
Page Title
If it is the rail that has the sheel metal that comes all the way up to the rail on the outside, I can offer the below post instead.
Scott Echols
Hi-Tek Stuff
Crazy Angler Tackle