I like mine. No problems with them at all.
Reviewing some rod holders, I know there were some older post about Cumberland Rod Holders, I researched and it seems they are built solid and easy to adjust with the Knobs? Any one use the Cumberland 360? Good, Bad, yeah or nah?
I like mine. No problems with them at all.
It is what it is!
Really like mine. They are well made with a lot of built in adjustability. Track mounting system allows me to switch between different boats if needed. I thought the price was reasonable for the quality of workmanship. They will also make you custom versions of their products as well. We are using a 6 pole spider rod set up in the front instead of 8.
CS
Thanks for the replies, My neighbor has Drift Masters, but then I looked at the ease with the turn knobs on the 360's seems easier, Crappie Snob, I will be using a six pole set up as well. So I take it you ordered the 360 3 rod holder? Does it have room to add a fourth if needed?
Yes. I have the 360 3 rod version. There is no room to add a 4th rod to the bar. There is one holder to the right of where the upright support attaches to the bar and two on the left. Works perfect for me since I have a smaller boat and not a lot of room up front.
CS
I have the 360 4 rod set up for 8 rods total. I drove down to their shop and picked mine up. I will have to say they are great people to deal with. Terry went above and beyond customer service.
I will tell you this, They have super fast service, will be here at the house tomorrow through UPS, cant wait to set it up, may buy additional after I see how they look and work, hopefully if this fricking weather straightens out I will use them these week!!!!
This would be a better post on the main page, but I have a 4 pole 360 and like it, only thing I dont like but it would be the case with any 4 pole T bar is that that all poles bounce when you grab just one. Other than that I like mine
Came in fast UPS, had it mounted in a matter of few minutes. quick pilot hole, four screws done.