Well Dan I hope you fixed the problem cause I have no ideer!Maybe put a rag on it then grip it with pliers?
I had to replace my 2 blade prop on my Motor Guide wireless. I finger tightened the nut that holds the prop on.
After using the TM only a short time it quit turning and found the motor locked up. I could not get the prop nut to loosen up, even with pliers.
Is it possible that the nut is too tight causing the motor to not turn?
I did not want to break the ears off the nut loosening it with needle nose pliers. Is there a better set of pliers or tool to use on those nuts so the ears don 't break off?
Well Dan I hope you fixed the problem cause I have no ideer!Maybe put a rag on it then grip it with pliers?
Life is good today.
Get rid of the plastic nut and replace it with a stainless steel nylock nut. Sounds like you may have gotten some line wrapped behind the prop. Braid will surely lock one up tight. Good luck.
Sent from my MB860 using Tapatalk 2