Lets see how this works. Someone ask for pics of my jig tying steps and I have not tried this slide show thing before so cross your fingers.
Just watched this slide show again and noticed I should have shown the chenille on the other side at some point, because I do wrap it away from me. Sorry for missing that.
Skip
Click on the link below (use to have a picture to click on, but can't figure it out again so just the link will show it). Just h
also below a few test video's I did a couple years back!
YouTube
Also adding the cutting of the little V's now...
MOV04332 mpeg2video - YouTube
Slide show pictures!
Start just tying the strip in and did a whip finish
back where it's tied in and a drop of superglue.
Take thread back to the head.
Starting the wrap.
wrapped to the head and trap.
Cut the excess hide off clean.
Make a good thread wrap and whip finish.
Finished!
Also here is a link to a post from a good while back about jig storage and ways to do that. This is pretty good, but maybe just the idea will give you a better idea?
Jig Storage, maybe a good one?