Tubing for slip bobbers?

[flytier]

Looking for the type of stiff hard plastic tubing to make bobbers from wine corks,something like 1/8 od with a hole in middle,any ideas?

[Grainraiser]

I use a plastic coffee stirrer when making slip corks out of Styrofoam floats. It's a tight fit so run a finish nail thru the straw and then run the straw thru the Styrofoam float. It works great.

[flytier]

I'll try that.

[snake River]

Also you could use a cocktail straws

[skiptomylu]

Maybe too large, but I used oxygen at night and have a lot of Green tubing for that. Would have to put a ruler next to it to see, but think a little larger than 1/8", but maybe a little less than 1/4". I am not sure, but if you think it would work I will check.

Skip

[RLS40]

There is some strong tubing used for spinner spacers that may meet your needs.

[RLS40]

There is some strong tubing used for spinner spacers that may meet your needs.

I got the spacer tubes at Lure Parts online. Part # 5532.

[flytier]

I found the coffee stirrers at a Wal mart store they should work good thanks all.

[Jamesdean]

On the stirer straws, make sure the tube is no longer than the cork. I use them and have found that the line will spit it and then hang up when it should slide through. But trimming it down to the cork solved this problem...

[SeaRay]

I found the coffee stirrers at a Wal mart store they should work good thanks all.

LOL, I got all mine at McDonald's. Everyt ime I grabbed a coffee when I was working I'd get a straw even though I drank it black.