Wanting to start tying

[clfarms1]

I am looking to start tying, I want to make my own gnats, for spider rigging. I just need to know what I need to buy to get started.I have been looking and think it wont be to bad. I know the more you get into it the more your going to end up with more supplies so any suggestions on tools and basic supplies to get started would be appreciated.

[Cray]

Steve, get you one of those inexpensive tying kits. Vise will hold your hooks and has all the tools you need to get started. Get you some spools of flat waxed 230 denier jig tying thread, some flash, and some rubber skirt material. All of it can be had from JannsNetcraft pretty reasonable. Watch some of the videos on YouTube and you can figure out how to tie in materials,wrap and tie off thread. Use clear Sally's hard as nails for thread sealer.

[clfarms1]

thanks Cray I was thinking that was about what I need to do. I know there is a lot of different prices out there on tools and I don't need the high priced ones, Im thinking one of the sets that cost 75 or less will get me everything I need and may be a little better set in that price range

[Gobob]

Tying a pretty simple crappie jig - YouTube check this one out Steve

[canebreaker]

There is a list of suppliers in here somewhere. I just shop around as to what looks good to me. You can over pay on some products from one supplier to another.
Check out the supplies/tools at walmart, craft jewelry making section. I needed a small side cutter of sinker/jig casting. I found this one at about half price as some other places. Wire And Rivet Flush Cutter - Walmart.com
I use the cheapest clear fingernail polish for thread sealer.
I use nylon thread from the fabric store.
Most of the hair comes from Wild Wolf, ShilohRed.
I bought this vise for a bit less than this. There's another one up for bid cheaper. I spotted a few kits at good prices as I was looking for this. Fly Tying Vise Lever Action Rotating Vise Clamp Base FV2135 New | eBay
I've found some seasonal items at Dollar Tree that can be used.

[Gobob]

Oops hit the wrong one ,this is the one I meant to post
Fly Tying for Beginners Marabou Jig with Jim Misiura - YouTube

[Gobob]

http://www.googleadservices.com/page.../CA79DWTK.html

[Fatman]

Right at the top of this section are some sticky's and one is From Someone new to tying http://www.crappie.com/crappie/jig-t...m/49489-tying/ Read through it and it will help you out and hopefully save you some money also.

Welcome to the madness!!!!!!!!!

[skiptomylu]

Yes welcome to the madness! I have not been on much as I have been sick. However we all here will help when you need it!
Be sure to read the link Fatman gave you, it should help a good bit!

[Gobob]

Thanks guys Get him all fixed up so he can make me some custom jigs lol. Go Steve Go