I got a few bags of rifle brass, mixed headstamps all the same cal. I dry tumbled it in Lizard litter desert blend first then decapped, sized and trimmed before going into the wet tumbler to make it shiny. Then sat down to prime them. About 10% of the cases are to large to fit the shell holder on the priming tool. I try another shell holder and get a few more primed. I emailed the brand of the priming tool and was told to mail it and a few cases and they would make adjusts to it.
I entered info on a reloading page and got a few answers. One was to resize the brass and then prime. I set the die up in the press and put the first case in. The case needs about 1/8" to bottom out in the die. So I press a little more. Snap, I break the pivot. I email the company again. Return the broken part and we will replace it.
I'm out of service until parts are delivered.