Thread: Oconne Boat Ramps...

Oconee is little over 2ft low and Sinclair just under 2 ft low.
As 11/7
Oconee (Wallace Dam) 0 432.66 435 (full pool)
Sinclair 0 0 338.11 340 (full pool)

Went yesterday and Sugar creek ramp is just fine.

Originally Posted by mtnman

Went yesterday and Sugar creek ramp is just fine.

Sugar Creek GA Power Ramp or Sugar Creek Marina ramp?

GA Power ramp. Last time I tried it at the marina ramp it was so low my prop was stirring up mud and the trailer dropped off the ramp about a foot and made it difficult to load the boat.

i have been putting in at blue springs and have not had any problems. then run down to sugar creek. just have to make sure you keep an eye out for the timber.if you stay in the main channel it all good.

Tried to get in at JR's in Lick Creek Friday but couldn't do it. Had to help a guy ahead of me with a small aluminum boat get off the trailer. Talked to a guy in the store who said very few ramps are still usable on the lake but depends somewhat on the trailer. Mine didnt egven come close to being able to come off. Turned around and drove to Sinclair. Marked a good number of fish but didnt do much.

Lately I have launched at the Sugar creek public ramp and long shoals and have had no trouble. I launched at Sugar Creek public ramp yesterday and had no problems launching my 18ft Ranger bass boat. Watched some guys at the Sugar creek marina ramp load a Ranger Comanche and a Skeeter and both of them did just fine. About 3 weeks ago I put in at sugar creek marina and the water was 2ft deep in the little cove that the ramps are in. Just make sure you trim the outboard up and your fine.

No problems ar Sugar Creek and Long Shoals. You can see the end of the ramps unless the water is too stained during the day so just don't back too far in.