I have a 997SI and have it hooked up to the cranking battery. When I start the motor it shuts down the 997, not enough voltage. My thought is this, I buy another deepcycle batt & run all the electronics to it, let the cranking batt do its only job, and have the 2 trolling batts do their only job. Does anyone have this set up, if not what do you have???
"Dixie Boy"
Monkey Town Jigs "The Evolution of Crappie Jigs"
Dayton, TN
You also might want to check the draw from your starter. If it is pulling a lot of amps, that would be causing your problem. <*)}}}><
You'll see the difference,,,on the end of your line! PROUD MEMBER OF TEAM GEEZER
CC how do you check the draw from the starter? I am an idiot when it comes to engines, bare with me!!
"Dixie Boy"
Monkey Town Jigs "The Evolution of Crappie Jigs"
Dayton, TN
also make sure all connections are clean and tight
Member BS Pro-Staff and Billbob Pro-Staff
Proud Member of Team Geezer... authorized by: billbob and "G"
that's what happened to me,I changed the deptfinder to it's own battery and of corse no problem anymore. lots of draw on the battery starting the motor. good luck
Brand new Optima d34m. Going with the d31M and see if that works. How do you charge the batt for the depthfinder, 3 bank charger or relay the cranking batt to the depth batt & let the altinator charge them both?
"Dixie Boy"
Monkey Town Jigs "The Evolution of Crappie Jigs"
Dayton, TN