Likes: 
HaHa: 
Reply With QuoteHere ya go. Just installed one on mine and went with 10.
https://www.minnkotamotors.com/suppo...-battery-guide
Slabmaster
Wire Size for Ulterra 24 volt
Does anyone know if the existing 8 AWG wire in my 17' Tracker is big enough for an Ulterra 24 volt 80 lb trolling motor?
Super Moderator
* Crappie.com Supporter * Member Sponsor
Here ya go. Just installed one on mine and went with 10.
https://www.minnkotamotors.com/suppo...-battery-guide
“If your too busy to fish, you’re too busy!” Buddy Ebsen
PROUD MEMBER OF TEAM GEEZER
(Billbob and “G” approved!)
Proud member of Tekeum’s Jigs Pro
Staff
https://heavenornot.net/
heavenornot.netkycreek thanked you for this post
Slabmaster
The chart goes from 8 AWG at 15’ to 6 AWG at 20’. I figure I’ll be in between.Originally Posted by BuckeyeCrappie
Minnow
I have a 2009 17.5' Tracker and using a 24v Ulterra 80lb for 4+ years, using factory wiring with no problem.
Crappie.com Legend
* Crappie.com Supporter
Slabmaster
Thanks for all the help. Got the Ulterra hooked up over the weekend and tried it out Sunday. Everything worked fine. I temporarily mounted the heading sensor by the console. Seems to work fine there. If I can figure out how to get the power back to the fuse block easily I may move it up front.
Super Moderator
* Crappie.com Supporter * Member Sponsor
Did ya put a circuit breaker in?
“If your too busy to fish, you’re too busy!” Buddy Ebsen
PROUD MEMBER OF TEAM GEEZER
(Billbob and “G” approved!)
Proud member of Tekeum’s Jigs Pro
Staff
https://heavenornot.net/
heavenornot.net
Slabmaster
Super Moderator
* Crappie.com Supporter
They can ne expensive. But they are well worth the money
The love for fishing is one of the best gifts you can pass along
Slabmaster
The new 3 bank charger and the Battery Tender plug is what was expensive.
