Is the Enduro a tiller type or foot control?
Sounds like it’s the speed control.
Sent from my iPhone using Crappie.com Fishing mobile app
I’m dumb.
TM works. Intermittently.
Say, I put it in forward... it won’t move til I max out that throttle position. I can slow that forward movement down if I back off. But ONLY once I’ve contacted the furthermost forward “throttle”.
Same scenario in reverse.
I had bought this TM for the variable control to slow up to tree tops and slowly keep place against slight river current and this just makes it useless and worse than a constant speed position on a TM.
For problem diagnosis, it’s hooked to its own group 29 deep cycle battery that is less than a month old.
I ain’t buying a new TM. I’ll jump back in my sculling bucket and make do, BUT if anyone’s gotta idear, I’d appreciate the input.
Thought maybe a switch or circuit board or etc but I’m super dumb with that and parts diagram doesn’t even label those parts....
Wonder why
Any help would be appreciated.
Adam
ILYL
Sent from my iPhone using Crappie.com
Is the Enduro a tiller type or foot control?
Sounds like it’s the speed control.
Sent from my iPhone using Crappie.com Fishing mobile app
If it’s a tiller handle that you twist the handle to control the speed, take the screws out of the head, remove the top plastic piece, and clean all the contacts up real good then put it back together.
Also remove the prop and check for mono wrapped around the motor shaft.
Don't ask me how I know....
Clint
Far West Kentucky
Old enough to know better and way too old to care!GrumpyLoomis LIKED above post
"Don't ask me how I know...." Amen Brother!!
If you don't find line wrapped around it I would go further into the motor and look it over. There is always the option of putting a power width modulator and control speed that way
Sent from my E6810 using Crappie.com Fishing mobile app