check to see if you have a Trolling motor circuit breaker that might have tripped !!!! it would look like this !!!!
Went out this morning an my remote for my Terrova won’t come on. Never had an issue with it before. I replaced battery with a new one and still nothing. Any ideas??
check to see if you have a Trolling motor circuit breaker that might have tripped !!!! it would look like this !!!!
"What if you woke up today with only the things you thanked God for yesterday"
"Life without God is like an unsharpened pencil - it has no point. "AMEN"
My Terrova remote uses 3 AA. With nothing from new batteries - call MK first thing. Best I can do. HTH YMMV
Circuit breaker has no effect on the remote - only the motor.
"Alive without breath, as cold as death; never thirsty, ever drinking, all in mail never clinking."
This old but worth a try.
Jason Halfen - "Page 33 on iPilot User Manual" (Thanks Jason)
Remote.Learning
The i-Pilot remote is prelearned to the controller from the factory. The top of
the controller has a single learn button to allow additional remotes to be added
to the system. To learn additional remotes:
1. Power up the trolling motor.
2. Push and hold the learn button down. a steady audio tone will be heard
while holding this button.
3. While holding the learn button down push any button on the remote
being programmed. Three beeps will be heard when the remote is
successfully learned.
a remote can only be learned to one controller at a time. a controller can have
an unlimited number of remotes learned to it. during the learn process, the
remote must start out in the off condition. If necessary, the remote can be
turned off by pressing and holding the Pause button for three seconds.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
I had one do that a few years ago, the little wire springy connector under the battery was bent just enough.....
This was my problem. Take the cover off. Make sure the batteries are good. Low odds the ones you put in there were bad but it is possible. Then make sure they are in correct. There is a diagram under the batteries. Keep pushing the metal clips around and rolling the batteries while testing if it'll cut on with battery cover off.
Sent from my E6810 using Crappie.com Fishing mobile app