Glue a good sized piece of plastic cutting board to the hull, and screw the transducer to that. Adhesive depends on boat material.
Bought a Garmin Striker 4. Was planning/wanting to glue the transducer in the hull. The instructions did not list that as an option.
Is it an option?
Or will I need to mount it on the transom ?
Drinkin coffee, missin fish.
Glue a good sized piece of plastic cutting board to the hull, and screw the transducer to that. Adhesive depends on boat material.
skunked again thanked you for this post
If the boat has a raised floor I believe you have to epoxy the transducer directly to the fiberglass skin of the boat. That usually means mounting in the bilge area or cutting an access hole in the floor.
Mark 1:17 ...I will make you fishers of menskunked again thanked you for this post
You an test the performance of shoot thru application by holding the xducer in place with a bag of sand (or similar) and adding water to the bilge above the xducer ...
Rickie
www.podunkideas.com <--Click here
------------—————
https://www.crappie-gills-n-more.com/
https://cornfieldfishinggear.com/
------------------------>> Pro Staff Sonar Advisorskunked again thanked you for this post
Rickie, will this simulate the transducer being epoxied in?
Drinkin coffee, missin fish.
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979
skunked again thanked you for this post