Thread: Mounting Raymarine CPT-DV transducer on Minnkota Edge 45

The transducer is 8" in length. The only possibility I see is drilling a hole in the skeg. Anyone have a better idea?

Check out transducer shield & saver. They may have a bracket that lets it work.


Sent from my iPhone using Tapatalk

Originally Posted by deltabound

Check out transducer shield & saver. They may have a bracket that lets it work.


Sent from my iPhone using Tapatalk

That's a darn good idea, they make some great products.

Originally Posted by deltabound

Check out transducer shield & saver. They may have a bracket that lets it work.


Sent from my iPhone using Tapatalk

...that they have anything that fits my transducer, and the cost for the closest thing 1s $159.

You may want to check these out also.
da 'ducer apparatus® - Podunk (po dungk) A small isolated town, region, or place that is regarded as unimportant. . . .

the "DA-DUCER" dvice will work with ANY 'ducer

Originally Posted by wannabe fisherman

the "DA-DUCER" dvice will work with ANY 'ducer

X2!

Ok guys I am in a pickle I purchased a Raymarine Dragonfly 7 Pro and a trolling motor mount but it won't fit my Minn Kota Edge 45 skeg is in the back and the Transducer is to long... Did anyone come up with a solution yet?



Sent from my iPad using Tapatalk

Originally Posted by Possum01

Ok guys I am in a pickle I purchased a Raymarine Dragonfly 7 Pro and a trolling motor mount but it won't fit my Minn Kota Edge 45 skeg is in the back and the Transducer is to long... Did anyone come up with a solution yet?



Sent from my iPad using Tapatalk

Minn-Kota says it will not invalidate warranty to drill a hole in the skeg. Bolt, nut, washers, hard rubber spacer, and a number of washers cut from an old inner tube. Works fine.

Originally Posted by wes75951

Minn-Kota says it will not invalidate warranty to drill a hole in the skeg. Bolt, nut, washers, hard rubber spacer, and a number of washers cut from an old inner tube. Works fine.

I did a simular fix by drillng fin and grinding down one ear that screw goes through it fits flush against fin and botton of fin rest on ducer
will send pictures post flu