Thread: Power drive v2 transducer mount and routing

I mounted a 1/2 thick piece of 4inch by 3 foot aluminum to the front of my bass tracker and then mounted a old trolling motor bracket to the aluminum. I've been using it for over 2 years now and it works great. I also mounted my side imaging transducer to the old trolling motor bracket so now its up front. One added benefit of this is I can grab the bar holding the transducer and twist it a 1/4 turn and my side imaging is looking forward and reverse.

cable save 'R
can be purchased at Hi TEC outdoors on Hwy 68 Draffenville Ky.
or www.cornfield crappie.com
I would suggest going to Hi Tec

Thanks. I just called them and they have to look into it to see if it works in a V2, etc.

They said it was on their website but I am not finding it, nor am I finding it via Google - and suggestions?

Thanks!

cornfieldcrappiegear

Here is the one fore ulterra. If you can give them the diameter of shaft and where shaft attaches to motor they should have it or be able to make it pretty quick.

Thanks again. I just called them to order - its not on their website - and they are shipping out one that fits my V2 Powerdrive.

Thanks to the forum i got mine hookd up. Now i got a cable going to the ftpedel and got it put together. Theres a smaller cable treaded in the coil from the head to somewhere. It screws into something somewhere but i dont no where. Thats where i need your help. You can get better info here than u can from minnkota.

If you have the US2 transducer, that's the cable you would attach the adapter cable from you depth finder to.