Thread: Dual color troubles

Did you bleed your injector of air bubbles if you poured plastic into it instead of sucking plastic into the injector? Might check your injector o ring. Also when I’m injecting a body onto a tail I shoot it hot. Like 375 and hold pressure. Too cool and not a good bond. I hear some people put their tails in the molds and then put on the molds on a hot plate to warm them up so that the tail plastic is heated.

Most of the time that’s because not enough air is getting out of the mold if it is not vented properly you will have problems I customize my molds if they need to be I don’t advise anybody to do that unless they know what they’re doing.

Thanks for the replies. I suspected the trouble with delamination when pouring could be resolved with warming the plates, but I wanted to bust them apart sooner than that allows.
For the injection issue, I suspected I needed a vent. I feel like injection would be much better than pouring. I'll have to give a solution for a vent some thought and trial one of the body cavities.